Stepper motor
hi all.
to whom may concern have 2 stepper motors trying make heat elements bend with. (using wire)
stepper motor 1 feeds , stepper motor 2 bends 180 degrees. question how or language supposed use tell feed 546 pulses bend (pulse 1000) right , bend (direction) 1000 left? advice helpful..thanks
to whom may concern have 2 stepper motors trying make heat elements bend with. (using wire)
stepper motor 1 feeds , stepper motor 2 bends 180 degrees. question how or language supposed use tell feed 546 pulses bend (pulse 1000) right , bend (direction) 1000 left? advice helpful..thanks
an interesting question - invent own, or perhaps use g-code x feed , axis bending? or use x , y, since grbl can handle out of box (it supports x,y,z run
on arduino).
i presume either want send instructions remotely, or pull them off sdcard?
whatever notation choose, in terms of distance , angle, not motor steps, is
too low-level. motor driving code setup has know details of motors.
on arduino).
i presume either want send instructions remotely, or pull them off sdcard?
whatever notation choose, in terms of distance , angle, not motor steps, is
too low-level. motor driving code setup has know details of motors.
Arduino Forum > Using Arduino > Motors, Mechanics, and Power (Moderator: fabioc84) > Stepper motor
arduino
Comments
Post a Comment