SIM800L GPRS GSM ( ROHS ) restarts every 10 seconds
hi
i experiencing above problem module

i using arduino mega 2560 1 and including softwareserial.h declare pins 10 , 11 as rx , tx in code
my pin connections module
sim800 5v/4v ↔ arduino 5v (or external power through mb102 breadboard power supply module 3.3v/5v arduino breadboard.. 1 below )

sim800 gnd (first one) ↔ arduino gnd
sim800 sim_txd ↔ arduino d10 tx
sim800 sim_rxd ↔ arduino d11 rx
sim800 gnd (second one) ↔ arduino gnd common reference tx,rx
with sim card in place , through serial monitor can send @ comands , receive messages
sending at , get :
ok
+cpin: ready
call ready
sms ready
sending at+cfun? , get :
+cfun: 1
sending at+creg? , get :
+creg: 0,2
sending at+cops? , get :
+cops: 0
sending at+cmgf=1 , get :
ok
sending at+csmp? , get :
+csmp: 17,167,0,0
but of these commands can send them between 10 seconds takes before restarts again
the module has 2 leds... 1 red on in these 10 seconds , second one red in colour blinking
when dont have sim card inside slot module doesn't restart , on with 2 leds working describe above
any 1 same problem , perhaps solution this? doing wrong ?
i experiencing above problem module
i using arduino mega 2560 1 and including softwareserial.h declare pins 10 , 11 as rx , tx in code
my pin connections module
sim800 5v/4v ↔ arduino 5v (or external power through mb102 breadboard power supply module 3.3v/5v arduino breadboard.. 1 below )

sim800 gnd (first one) ↔ arduino gnd
sim800 sim_txd ↔ arduino d10 tx
sim800 sim_rxd ↔ arduino d11 rx
sim800 gnd (second one) ↔ arduino gnd common reference tx,rx
with sim card in place , through serial monitor can send @ comands , receive messages
sending at , get :
ok
+cpin: ready
call ready
sms ready
sending at+cfun? , get :
+cfun: 1
sending at+creg? , get :
+creg: 0,2
sending at+cops? , get :
+cops: 0
sending at+cmgf=1 , get :
ok
sending at+csmp? , get :
+csmp: 17,167,0,0
but of these commands can send them between 10 seconds takes before restarts again
the module has 2 leds... 1 red on in these 10 seconds , second one red in colour blinking
when dont have sim card inside slot module doesn't restart , on with 2 leds working describe above
any 1 same problem , perhaps solution this? doing wrong ?
ok find out strange....
this happens when have connected antenna module
when antenna out module works fine without restarting (i havent test send @ comands guessing not able find gsm network

so idea ?
thanks in advance
this happens when have connected antenna module
when antenna out module works fine without restarting (i havent test send @ comands guessing not able find gsm network
so idea ?
thanks in advance
Arduino Forum > Using Arduino > Networking, Protocols, and Devices (Moderator: fabioc84) > SIM800L GPRS GSM ( ROHS ) restarts every 10 seconds
arduino
Comments
Post a Comment